The CharkBoards!
Avet SX question

This topic can be found at:
http://charkbait.evecommunity.com/eve/forums/a/tpc/f/4381010491/m/849004285001

10 October 2011, 06:53 PM
troutdan
Avet SX question
I'm a new member to the board but have picked up many great tips from the board over the years. My question concerns my Avet SX MC. I have fished the reel from the beach for 2 seasons. I tore it down this week for maintenance and found it looking great inside. All I had to do was clean and re-oil bearings. Since it was apart I took the opportunity to grease the drag and all the screws before reassembly. When replacing one of the screws in the dog cover I noticed grease oozing out of a small lump / pin hole in the back side of frame. Is it possible that pressure build up could actually pop a hole in a machined frame? The screw was not tightened that much. I have worked on many other reels and never seen or heard of anything like this.
16 October 2011, 09:51 PM
alantani
yup, you pushed the grease right through. don't worry, though. the damage was cosmetic only.